Install-Slipcovers-Stretch Semi-Custom w Bench Seat

How to Install
Slipcovers - Stretch Slipcover with Separate Seat Cushion Cap

Slipcovers - Stretch Semi-Custom Look with Seperate Bench Seat

1. LOCATE
Locate "Centre Front", "Centre Back" and "Arm” tags.

2. REMOVE SEAT CUSHION AND DRAPE SLIPCOVER.
First REMOVE seat cushions.
Drape slipcover, pulling down over the furniture using positioning tags.

3. STRETCH, TUCK AND SECURE
Stretch fabric behind to position elastic under all sides. Line up seams on seat area and tuck excessive fabric into arm crevices.

It is important to start on one side, setting the cover on one arm as shown. Then stretch around the back to the other arm lining up the back seams at back corners.

Secure under furniture keeping the seams lined up with arms as you pull down evenly to match contour. Stretch fabric as needed and watch it recover quickly!

4. INSERT CUSHION(S)
Insert cushions into zippered cover. You may need to overlap cushions when inserting them into a seat cover and then flatten them before you zip the cover closed..

5. PLACE SEAT CUSHION(S)
Place seat cushions with zippered closure facing the back. Smooth excess fabric and tuck creases on all three sides.

6. VOILA!
When finished, your slipcover should fit snuggly, almost like it was custom-made.

It's "sure" to make a positive impression!