How To Install

Slipcovers - Classic

Slipcovers - Stretch Fit

Slipcovers - Wrap Style

Slipcovers - Wrap Style  - Separate Cushion Cap and Separate Bench Seat Cushions

Slipcovers - Stretch Semi-Custom Look with Seperate Bench Seat

Throws

Recliner Covers

Dining Room Chair Covers

Dining Room Chair Covers - Stretch

Wing Back Chair Covers

Wing Back Chair Covers - Stretch

Ottoman Covers

Futon / Davenport Slipcover - Stretch

How To Measure

FAQ’s

Contact Us

How to Install
Recliner Covers

		1. ARM COVERS - Locate the label marked "Front of Arm" and locate loop ties at the corner. Put the cover over the arm with the loop ties on the outside of the chair. Pull down until the tab and loop ties are in place. Make sure that the footrest handle protrudes through the opening in the cover.
		2. BACK OF CHAIR COVER - Locate the label marked "Top of Back" and locate loop ties at the corners. Put the cover over the chair with the loop ties on the outside of the chair. Pull down until the tab and loop ties are in place.
		3. SEAT/FOOTREST COVER - Recline backrest slightly and raise footrest. Locate label marked “Front” and place around front of footrest. Place the back of cover around the back of the seat. Adjust by tucking excess material into crevices between arms, back and seat.
		4. SEAT/FOOTREST COVER - Secure the arm ties to the back loop ties and tuck under chair. Take a minute to make sure seams follow the outline of the furniture and stretch is even throughout the chair. This will assure a better looking and longer lasting slipcover.
		After the pieces are put on, carefully trim the labels off by cutting close to the seams with scissors and, you’re DONE!